Motorola AP 73 User Manual page 44

Scan Operations
Pressing Push-To-Talk (PTT) Button (6) , a digit on
the numeric keypad,
scanning.
The 'SCAN' indicator turns off when scanning is
terminated and the radio displays the frequency
where scanning stopped.
IMPORTANT
If both memory channels are left blank (unpro-
grammed), the radio scans the entire frequency
band. If channel 19 is programmed but channel 20
is blank, the upper frequency limit becomes the
highest frequency in the band. If channel 20 is pro-
grammed but channel 19 is blank, the lower fre-
quency limit becomes the lowest frequency in the
band. If the frequency stored in channel 19 is lower
than that stored in channel 20, then scan proceeds
in an incrementing order otherwise, scan proceeds
in a decrementing order.
Transmitting During Band Scanning
When the scan is locked at a frequency:
• Press Push-To-Talk (PTT) Button (6).
IMPORTANT
As soon as Push-To-Talk (PTT) Button (6) is
pressed, the radio exits band scanning and trans-
mits the TX frequency which corresponds to the
active RX frequency, plus or minus any selected TX
offset. If the user-defined mode is selected ('+' and
'–' indicators both on), the radio transmits the user-
defined TX frequency.
36
NOTE
or also ends the
NOTE
2-Year Warranty