Yamaha AR240 HO Owner's Manual page 70

3
o
peratIon
Bimini Top Limited S
Raising from the Collapsed position:
1) Unbuckle the cover straps from
around the top tubes of the Wa-
tersports Tower, then unzip and
remove the storage cover.
2) Zip the three flaps at the front of
the canvas around the top tubes of
the tower.
3) Unfold the top by pulling it to
the back of the boat (toward the
stern).
4) Attach the tension strap snap
hooks to the strap eyes.
5) The top should be snug and wrin-
kle free. If the top is too loose, or
too tight, adjust the rear straps by
sliding the buckle up or down the
strap as needed.
NOTiCE:
do not exceed 45 mph (72 km/h)
with the Bimini top in the deployed
position.
Storing and Trailering
1) Unhook the rear straps. Pull the
Bimini top to the bow of the boat
and gather it at the front bar of the
Watersports Tower.
2) Unzip the three flaps from around
the tower tubes
3) Zip the storage cover in place and
secure it to the Watersports Tower
by buckling the cover straps around
the top tubes.
NOTiCE:
do not trailer the boat with the
Bimini top in the fully extended po-
sition. put the cover over the top to
avoid damage.
Removing the Bimini Top
1) Unbuckle the storage cover (if
attached).
2) Unscrew the knobs holding the
rear support arms for the Bimini
top to the Watersports Tower.
3) The top can now be removed from
your boat.
When reinstalling the Bimini top, simply
reverse the removal steps, making sure
the knobs holding the support arms are
tightened securely (see page 4-4 for
Bimini top care information).
3-14