Using Your Coffeemaker - Auto Mode - West Bend L5629A Instruction Manual

coffee to start. After using your coffeemaker a few times, you can adjust the
amount of coffee to suit your own taste. NOTE: The coffee grind should be
appropriate for a "drip" coffeemaker. Do not use coffee that is ground to a
powder like consistency. This will prevent water from passing through the
coffee and may cause hot water or hot coffee to overflow.
3. Open the hinged water reservoir cover. Using the carafe pour in the desired
quantity of clean cool water for the number of cups you are brewing. Close the
hinge reservoir cover. Never pour more water into the reservoir than the
marked maximum level. Do not use warm or hot water to fill reservoir.
4. Place the carafe with cover in position on the coffeemaker base. Make sure the
carafe sits flat on the inside circle of the coffeemaker base. . The cover of the
carafe must be in place and properly positioned on the carafe during the brew
process or hot water or hot coffee may overflow.
5. Push the On/Off button to turn the coffeemaker on. The red power indicator
light will illuminate indicating that the brewing process has begun. If the coffee
carafe is removed before the end of the brew cycle, it must be returned properly
to the coffeemaker base so the coffee may continue to brew and to avoid hot
water or hot coffee overflow.
6. When the brewing cycle is complete, the coffeemaker will beep to announce
completion and the red power indicator light will go out indicating unit is off.
7. After coffee has been served, follow the directions in "CLEANING YOUR DRIP
COFFEEMAKER" section to clean your coffeemaker.
•
A small amount of smoke and/or odor may occur upon heating due to the
release of manufacturing oils – this is normal.
•
Some minor expansion/contraction sounds may occur during heating and
cooling – this is normal.
•
Pause 'n Serve Feature: The Pause 'n Serve Feature allows you pour a cup of
coffee while still in the brewing process. For optimum flavor, allow half the
quantity of coffee to finish brewing before removing carafe. Return carafe within
30 seconds so the coffee may continue to brew and to avoid hot water or hot
coffee overflow. To prevent scald injury, do not remove any part of
coffeemaker, other than carafe, during the brew cycle.
Using Your Drip Coffeemaker – Auto Mode
Your West Bend Housewares Coffeemaker can be set up to 24-hours in advance to
turn on and brew at a pre-programmed time.
1. Prepare your coffeemaker as described in the Preparing Coffee section except
do not turn the coffeemaker on when ready. Make sure the carafe with cover is
in place.
2. Ensure the clock has been set to the correct time of day following the
instructions in the "Setting Clock" section of this manual.
3. Press the Program button once. The program indicator light and the display
numbers will flash.
4. Press the Hr (hour) button to change/set the hour of the day for auto start. The
hour number in the display will advance in one-hour increments. When
advanced past 12:00, the display will switch between AM and PM.
5. Press the Min button to advance the minutes to the desired auto start time.
6. Press the Program button to confirm the start time setting. Auto-mode is
initiated and the Program indicator light will be illuminated. Note: If the Program
5