Midi Functions; Midi Transmission Settings - Numark EM260 Owner's Manual

MIDI FUNCTIONS

With the factory settings, each operation will transmit the following MIDI messages.
Operation
Touch panel X-axis
Touch panel Y-axis
Touch panel
X+Y axis ( d i a g o n a l )
Touch panel on/off
FX ON/OFF
Change Program
*The MIDI messages that are transmitted can be selected in the range of CC#1–CC#31 and CC#64–CC#95. In MIDI Edit mode (
"MIDI transmission settings") you can hold down the corresponding switch and rotate the PROGRAM knob to select the desired
control number.
A control number that has already been assigned cannot be selected in duplicate.

MIDI transmission settings

When you press the six PROGRAM MAP keys simultaneously, you will enter MIDI Edit mode. If you then perform no operation for
approximately 10 seconds or if you touch the touch panel, you will return to normal mode.
In MIDI Edit mode, you can use the following operations to change the MIDI transmission settings.
• PROGRAM knob: Set the MIDI transmission channel (1–16)
• PROGRAM MAP keys, FX ON/OFF, HOLD switches: Turn transmission on/off for each type of MIDI message (refer to
"Transmission on/off" in the above table).
Precautions with the KAOSS PAD
Usage -Never press down too hard on the touch panel, or place a heavy object on it. Rough handling can
cause it to crack or break. Rubbing or pressing the touch panel with a sharp object can scratch it, so only
use your finger to operate it. If cleaning is necessary, wipe only with a soft dry cloth. Using solvents such as
thinner may melt the surface of the touch panel. Note: Affix the included protective label to extend product
life.
Location -Using the unit in the following locations can result in a malfunction.
• In direct sunlight
• Locations of extreme temperature or humidity
• Excessively dusty or dirty locations
• Locations of excessive vibration
Interference with other electrical devices -This product contains a microcomputer. Radios and televisions placed
nearby may experience reception interference. Operate this unit at a suitable distance from radios and
televisions.
Handling -To avoid breakage, do not apply excessive force to the switches or controls.
Care -If the exterior becomes dirty, wipe it with a clean, dry cloth. Do not use liquid cleaners such as benzene or
thinner, or cleaning compounds or flammable polishes.
©2001 Industries
MIDI messages transmitted
Pitch bend messages
Effect Control 1 message (CC#12)*
Modulation 1 Depth message (CC#1) Y = 5–9
Modulation 2 Depth message (CC#2) Y = 5–1
Effect 3 Depth message (CC#93)*
Effect 2 Depth message (CC#92)*
Effect 4 Depth message (CC#94)*
Program Change message (1–60)
- The Leader in DJ Technology
Transmission on/off
En 00 00–En 7F 7F PROGRAM MAP1
Bn 0C 00–Bn 0C 7F PROGRAM MAP5
Bn 01 00–Bn 01 7F PROGRAM MAP2
Bn 02 00–Bn 02 7F PROGRAM MAP3
Bn 5D 00–Bn 5D 7F PROGRAM MAP4
Bn 5C 7F/Bn 5C 00 HOLD switch
Bn 5E 7F/Bn 5E 00 FX ON/OFF
Cn 00–Cn 38
- 9 -
EM260
http://www.numark.com