Headers - JETWAY Kocab 18G User Manual

•
Two hard disks can be connected to each connector. The first HDD is referred to as the
"Master" and the second HDD is referred to as the "Slave".
•
For performance issues, we strongly suggest you don't install a CD-ROM or DVD-ROM drive
on the same IDE channel as a hard disk. Otherwise, the system performance on this channel may
drop.
(12) Third IDE Connector (40-pin block): IDE3 (Master Mode only)
This connector supports the provided IDE hard disk ribbon cable. After connecting the single
plug end to motherboard, connect the two plugs at other end to your hard disk(s). Because this
connector only support Master Mode, you must configure the drive to Master mode by setting
its jumpers accordingly. Please refer to the documentation of your hard disk for the jumper
settings.
(13) Serial ATA IDE Connector (7-pin block): SATA1/ SATA2
This connector support the provided Serial ATA IDE cable for connect the Serial ATA hard
disk.

2-6-2 Headers

(1) Serial Port2 COM2 Header (9-pin) : COM2 (only for Kocab 18G)
IDE3
Pin 1
Pin 1
SATA2
SATA1
Serial-ATA Port Connector
15