Table of Contents
Advertisement
This motherboard provides an AGP Slot, support the 4X/8X AGP VGA card.
2-6 Connectors, Headers
2-6-1 Connectors
(1)
Power Connector (20-pin block) : ATXPOW
ATX Power Supply connector. This is a new defined 20-pins connector that usually comes
with ATX case. The ATX Power Supply allows to use soft power on momentary switch that
connect from the front panel switch to 2-pins Power On jumper pole on the motherboard.
When the power switch on the back of the ATX power supply turned on, the full power will not
come into the system board until the front panel switch is momentarily pressed. Press this
switch again will turn off the power to the system board.
(2)
PS/2 Mouse & PS/2 Keyboard Connector: KYB
The connectors for PS/2 keyboard and PS/2 Mouse.
(3)
USB Port connector: USB/USB1
The connectors are 4-pin connector that connect USB devices to the system board.
(4)
LAN Port connector: LAN
The connector is standard RJ45 connector for network connection
(5)
Parallel Port Connector (25-pin female): LPT
Parallel Port connector is a 25-pin D-Subminiature Receptacle connector. The On-board
Parallel Port can be disabled through the BIOS SETUP. Please refer to Chapter 3
"INTEGRATED PERIPHERALS SETUP" section for more detail information.
(6)
Audio Connector : LINE-OUT/LINE-IN/MIC
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC
LINE_O :
LINE_I :
MIC :
(7)
VGA Connector (15-pin D-Sub) Connector: VGA (for Kocab 18G only)
AG P SLO T
PIN
1
3.3V
2
-12V
3
GND
4
Soft Power On
5
GND
6
GND
7
GND
8
-5V
9
+5V
10
+5V
Pin 1
Audio output to speaker
Audio input to sound chip
Microphone Connector
ROW2
ROW1
3.3V
3.3V
GND
5V
GND
5V
GND
Power OK
+5V (for Soft Logic)
+12V
13
Advertisement
Table of Contents
