Ultra Start 1270 series Install Manual page 20

INSTALL GUIDE
Menu 3- Starter Settings
Ignition 3x
On/Off
On/Off On
Setting 1 Special Door Lock/Unlock Operations
1) Type 1 1 Flash/Chirp
2) Type 2 2 Flashes/Chirps
*3) Type 3 3 Flashes/Chirps
Press & Release the Program Button 1 Time (Setting 1) Confirmed with 1 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 2 Gas/Diesel Mode
1) (-) Input
2) Time Delay
*3) Gas/ (+) Input
Press & Release the Program Button 2 Times (Setting 2) Confirmed with 2 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step
Setting 3 Rearm Output
1) Type 1
2) Type 2
*3) Factory Re-arm
Press & Release the Program Button 3 Times (Setting 3) Confirmed with 3 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 4 Run Time
1) 4 Minutes
2) 45 Minutes
*3) 15 Minutes
Press & Release the Program Button 4 Times (Setting 4) Confirmed with 4 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Press and
Press and
Release the
Release the
Program
button for
Button
Menu 3
Unlock before start. Lock pulse after start and shutdown.
Lock pulse ONLY after remote start shutdown.
Default Lock/ Unlock Pulses.
(14 pin auxiliary connector, pin 14)
1 Flash/Honk
2 Flashes/Honks
3 Flashes/Honks
(14 pin auxiliary connector, pin 1)
1 Flash/Chirp
2 Flashes/Chirps
3 Flashes/Chirps
1 Flash/Chirp
2 Flashes/Chirps
3 Flashes/Chirps
Press and Release
the Program Button
Number of Times for
the Setting Chosen
(Factory Alarm Rearm).
(-) Glow Plug input. Waits maximum 30 seconds.
Waits for approximately 15 seconds.
Waits 2 seconds if no diesel input is detected.
.
Pulse after start and with lock.
Pulse after start only.
Pulse with lock and after starter shutdown.
Runs for approx. 4 minutes when activated.
Runs for approx. 45 minutes when activated.
Runs for approx. 15 minutes when activated.
PAGE 20
Press and Hold
the Program Button
to Change Option
*(Default Settings)