Auxiliary Connectors - Ultra Start 1270 series Install Manual

PAGE 11
Step 1 - Connect All Of the Following Wires
Main Connector
YELLOW
Starter Output - 12volts during start position only.
GREEN
Heater/Acc Output - 12volts in the accessory position off during
RED
12volt 30amp Input - 12volts from ignition harness or battery.
RED
12volt 30amp Input - 12volts from ignition harness or battery.
BLUE
Ignition Output - 12volts in the ignition, start and run positions.
WHITE*
Selectable Output - Selectable Output for vehicles that may
Auxiliary Connector
BLACK
WHITE
GRN/WHT
BLUE/WHT
PINK
for alarm series
GREEN**
or Door pin Input - Connect to (-) wire when door open
PURPLE**
Important!
Never install an AUTOMATIC TRANSMISSION module into a
MANUAL TRANSMISSION vehicle!
(6pin)
System Ground Input - Connect to Chassis Ground.
Park Light Output - Connect to Park Light system.
Hood Pin Input - Connect to the Hood Pin Safety Switch.
Tach Input - Connect to A/C Tach source. (Above 2 volts AC)
Brake Switch Input - Connect to 12volts when the brake pedal
(2270/4270/4265 series)
Door pin Input - Connect to (+) wire when door open
start and 14volts during run.
require a 2nd Ignition, Accessory or Start.
(14pin)
is applied.
*See jumper selector position (page 7).
**Connect only ONE of the door input wires.
INSTALL GUIDE