Table of Contents
Advertisement
Quick Links
BEDIENUNGSANWEISUNG
mit Montageanweisungen
Instructions for use and installation instructions
Instructions d' utilisation et avis de montage
Gebruiksaanwijzing en montagehandleiding
Istruzioni di l'uso e di montaggio
Instrucciones de Uso e Instrucciones de Montaje
Instruções de uso com indicações para montagem
IKD 908.1/IKDEM 908.1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Küppersbusch IKD 908.1
Summary of Contents for Küppersbusch IKD 908.1
- Page 1 Montageanweisungen Instructions for use and installation instructions Instructions d’ utilisation et avis de montage Gebruiksaanwijzing en montagehandleiding Istruzioni di l’uso e di montaggio Instrucciones de Uso e Instrucciones de Montaje Instruções de uso com indicações para montagem IKD 908.1/IKDEM 908.1...
-
Page 2: Table Of Contents
Attaching the hood body to the chimney Fastening the switch and control unit Mounting the glass shelf Mounting the bottom chimney panelling Installing the fume trap Mounting the filter mesh Guideline for extraction paths..22 IKD 908.1... -
Page 3: Your Appliance At A Glance
Your appliance at a glance IKD 908.1... -
Page 4: Safety Instructions
– If the cooker hood is only used in recirculation mode - with activated the right-hand button on the charcoal filters - there are no restrictions on operation. control panel to reset the working hour counter to zero. IKD 908.1... -
Page 5: Using The Appliance
To set the highest speed setting – immediately (high-speed setting), press the raised button on the right. The high-speed setting provides about 20% more power than the highest speed that you can set with the plus button. IKD 908.1... -
Page 6: The Cleaning Interval For The Fat Filters
Odours Remove the cover of the remote control. – Undo the battery connections. – Remove the battery, insert a new one (9V E-block) and connect it. – Close the cover again. – IKD 908.1... -
Page 7: Replacing A Halogen Lamp
Please also observe the notes on fume extraction on page 22. Before carrying out any repair work, the appliance must bediscon- The island canopy hood IKD 908.1/IKDEM 908.1 can only be connected as nected from the power supply by pulling out the mains plug or an extractor;... -
Page 8: Marking And Drilling Holes
Pass the customer’s power cable and, where applicable, the control cable – of the external motor through the ceiling plate of the inner frame. Push the upper chimney panelling – Screw the inner frame to the – over the inner frame and screw ceiling. on with two screws. IKD 908.1... -
Page 9: Connecting The Hood
Turn the hood body until the – screws are hanging in the narrow end of the screw holes. Fasten the glass shelf to the – Tighten the screws. – bottom chimney panelling with the four chromium-plated screws. IKD 908.1... -
Page 10: Mounting The Bottom Chimney Panelling
The control element is held with – Screw the filter and filter mesh – clips. Carefully push the element under the hood again. into the holder until an audible click confirms that it is sitting tight. IKD 908.1... -
Page 11: Guideline For Extraction Paths
The crucial factor is the correct transition of the exhaust channel into the chimney. Correct Best way Incorrect! The height of the exhaust pipe must not exceed 2.5 m. The pipe must be heat insulated or an air-trap seal must be installed. IKD 908.1...
Need help?
Do you have a question about the IKD 908.1 and is the answer not in the manual?
Questions and answers