Operation - Remington 482 Operating Instructions Manual

90˚
5. Place the muzzle of tool perpendicular to work surface without tilting the tool. Push
tool against work surface until sliding action of barrel stops.
6. Squeeze trigger to set power fastener. Be sure to keep pressure on tool during this

operation.

7. After fastening is made, slide barrel forward rapidly. This motion ejects the spent
power load and resets the piston for the next fastening. Make sure spent load has
ejected from tool.
30
482-45
8. Should the tool fail to fire, hold the muzzle firmly against the work surface for 30
seconds. Release the trigger and remove pressure on the tool while holding the
muzzle against the work surface. Again press the tool firmly against the work surface
and pull the trigger. If the tool still fails to fire, hold the tool firmly against the work
surface for another 30 seconds before unloading and carefully discarding the
misfired power load into water or oil.
106088
482-74
482-76
482-77
482-75
WATER
15
Operation