Remington 482 Operating Instructions Manual page 11

482-58
6. Power fasteners are a permanently installed fixture. An act of demolition is required
for their removal. Appropriate safety precautions must be taken.
Head
Shank
Plastic Flute
482-60
7. NEVER use common nails or other materials as fasteners. Remington Power
Fasteners are manufactured from special steel and heat treated to produce a very
hard yet ductile fastener.
8. NEVER pry a power load out of the tool. Prying can discharge the load causing
serious injury (see Troubleshooting Guide , page 16).
LOAD
1 2
9. ALWAYS insert the power fastener first, then the power load. If work is interrupted
for any reason, ALWAYS remove the power load before removing the power
fastener (see page 15, item 7).
106088
Safety Precautions
UNLOAD
2 1
11