Warning: Safety Precautions - Remington 482 Operating Instructions Manual

The following pages contain detailed warnings, cautions, and rules of safe operation.
Read carefully and become familiar before operating to avoid serious injury. We
expressly disclaim any liability for any injury to persons or damage to property which
result from your failure to take the precautions contained in this manual.
WARNING: This tool is designed only for use by qualified operators. Qualification
is obtained through a thorough understanding of the Safety Warnings and operating
instructions as defined in this operating manual. NOTE: Your local labor regulations may
require that the operator of this tool on a job site be thoroughly trained and certified for
competence prior to operating this tool. For certification procedures, call 1-800-626-2237
(U.S.A.) or 1-905-826-8010 (Canada)
BEFORE USING
?
1. ALWAYS handle the tool as if it were loaded. Before starting work, check that the
tool is unloaded and the muzzle is clear. NEVER load a tool unless it is going to be
used.
2. ALWAYS inspect to make sure the tool is working properly. If the tool does not work
properly, remove from service and tag DEFECTIVE. DO NOT use the tool again until
it has been properly repaired.
3. Operators and bystanders must ALWAYS wear goggles and hearing protection
which meet or exceed the accepted standards for adequate protection in your
country. In the U.S., refer to ANSI standards. In Canada, refer to CSA standards.
106088

Warning: Safety Precautions

?
3