Troubleshooting; Parts Central - Remington 482 Operating Instructions Manual

Troubleshooting Guide (cont.)
PROBLEM
Tool does not
completely depress.
Tool does not fire.
Opening and closing
of barrel or pushing
down of the tool, etc.
is not smooth but is
rough or binds.
Contact authorized dealers of this product. If they can't supply original replacement part(s),
either contact your nearest Parts Central (see below) or call DESA International's Parts
Department at 1-800-972-7879 for referral information.
In Canada call 1-905-826-8010.
When calling DESA International, have ready
• model and serial numbers of your tool
BALTIMORE ELECTRIC
1348 Dixwell Avenue
Hamden, CT 06514-0322
1-800-397-7553
203-248-7553
Parts Department
*ALL TOOL & FASTENER
7830 N.W. 72nd Avenue
Miami, FL 33166
305-888-6909
Parts Department
*PORTABLE HEATER
PARTS
342 No. County Road 400 E.
Valparaiso, IN 46383-9704
219-462-7441
1-800-362-6951
106088
POSSIBLE CAUSE
Misassembled or damaged
breech and firing pin parts.
Failure of tool to depress com-
pletely.
Dirt buildup on breech not al-
lowing proper penetration of fir-
ing pin.
Breech screw loose.
Lack of proper cleaning.
*F B D
1349 Adams Street
Bowling Green, KY 42103-3414
270-846-1199
1-800-654-8534
ROBI TOOL SALES
160 Broadway
Somerville, MA 02145-0002
617-776-1234
MASTER PARTS DIST.
1184 Wilson Ave. NW
Grand Rapids, MI 49544-3458
US 1-800-446-1446
616-791-0505
Mike Fowler
*MANZO ASSOCIATES
1645 Bustleton Pike
Feasterville, PA 19053-7305
215-364-0480
Parts Department
REMEDY
Remove breech and check all
parts for correct fit assembly.
See data listed under Tool
Does Not Completely Depress,
above.
Check firing pin indentation on
cartridge. Clean breech,
breech face, and firing pin.
Tighten breech screw.
Inspect and clean complete
tool (see Maintenance on page
16). Replace worn or damaged
parts.
Parts Dealers
• replacement part number
21st CENTURY
2950 Fretz Valley Road
Perkasie, PA 18944-4034
215-795-0400
1-800-325-4828
Parts Department
BLUEBONNET TOOL
10490 Shady Trail
Suite 104
Dallas, TX 75354-1145
214-358-2363
Ken Perry
*Certified For Service
17
*Certified For Service