Table of Contents
Advertisement
Operation
1.
Grasp barrel assembly and slide forward rapidly until it stops. Push barrel
assembly back into tool to the closed position. This sets piston into firing position.
2.
Insert power fastener into muzzle of tool, head end first. Push the fastener until
point is even with end of muzzle.
3.
Select the proper power level of power load strips and power indicator setting
(see Power Loads and Power Indicator Setting, page 13). Always insert power
load strips through bottom of handle. Push power load strip in until even with
bottom of handle.
4.
Place the muzzle of tool perpendicular to work surface without tilting the tool.
Push tool against work surface until sliding action of barrel stops.
14
NOTE:
Failure to start with
the proper power
level and power set-
ting can result in over-
drive condition and
will result in damage
to tool (See page 13).
106763
Advertisement
Table of Contents
