Operation - Ariens Pro Track 28 Manual

WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: To avoid injury to hands
and feet, always disengage
clutches, shut off engine, and wait
for all movement to stop before
unclogging or working on snow
thrower.
Keep hands and feet away from
auger and impeller.
CONTROLS AND FEATURES
See CONTROLS and FEATURES on
page 12 for all Controls and Features
locations.
Dual Handle Interlock
When Attachment Clutch and then Traction
Drive Clutch are engaged, the Attachment
Clutch will remain engaged (lever down) if
released. To stop attachment, release
Traction Drive Clutch and both clutches will
disengage.
Traction Drive Clutch -
Left Hand Lever
2
1
OL2701
be cleared, press down on the handlebars
enough to raise the front of the unit slightly off
the surface. Engage the traction drive clutch
without engaging the attachment drive clutch.

OPERATION

Squeeze the Traction
Drive Clutch Lever
against the Handlebar
(1) to engage wheel
drive for propelling unit.
Forward speed will
vary according to snow
depth and moisture
content.
Release lever (2) to
stop movement.
NOTE: When traveling
to or from the area to
Attachment Clutch -
Right Hand Lever
in the auger housing. Immediately release the
attachment clutch lever and move the unit
into a heated area to thaw.
NOTE: If belt squeals when impeller turns
freely, see Attachment Clutch/Brake
Adjustment on page 26.
Ignition Switch (926037, 038, 039, 040,
041, 042, 043)
Ignition Switch (12V start on dash
panel) (926104, 105)
1
2
3
OS0232
Primer Bulb
OS7320
GB - 13
Squeeze Attachment
2
Clutch Lever against
handlebar (1) to
engage attachment.
Release both clutch
levers (2) to disengage
power and apply brake
to attachment.
1
IMPORTANT: If the
belt squeals when the
attachment clutch lever
OL2691
is engaged, the
impeller may be frozen
Operate the ignition switch with
the removable key. To start the
engine, turn the key to Start. To
stop the engine, turn the key to
Off.
The ignition switch is
operated by a removable
key. It has three positions:
1.Stop
2.Run
3.Start
Pushing the primer bulb in adds
fuel for easier engine start.
Refer to Starting and Shut Off
on page 18.