Ariens Pro Track 28 Manual page 26

8. Adjust pivot pin on the shift rod as
necessary so unit travels forward when
speed selector is in first forward position
and travels backward when speed
selector is in first reverse position.
9. Connect the pivot pin to the speed
selector arm with the hardware removed
in step 1.
1
4
3
1. Shift Rod
2. Adjustment Pivot Pin
3. Speed Selector Lever
4. Hairpin
Figure 27
ATTACHMENT CLUTCH/BRAKE
ADJUSTMENT
IMPORTANT: IMPROPER
ADJUSTMENT could result in
unexpected movement of auger and
impeller causing death or serious
injury. Auger/Impeller must stop
within 5 seconds when Attachment
Clutch/Impeller Brake lever is
released.
Remove Attachment Cable Slack
(Figure 28 and 29)
1. Shut off engine, remove key, disconnect
spark plug wire and allow unit to cool
completely.
2. Loosen hardware securing belt cover to
unit.
NOTE: DO NOT completely remove the
hardware from unit.
3. Remove belt cover.
4. Loosen jam nut on cable adjustment
barrel, and then turn the adjustment
barrel up or down to lengthen or shorten
cable and remove all cable slack
(Figure 28).
1
2
3
2
5. With the attachment clutch disengaged,
check that the attachment idler arm
OS7185
lightly touches the frame (Figure 29).
6. Tighten jam nut on the adjustment
barrel.
\
With the attachment clutch disengaged,
check the attachment idler arm position
here. The attachment idler arm should
lightly touch the frame.
GB - 26
1. Attachment Clutch Cable
2. Adjustment Barrel
3. Jam Nut
Figure 28
Figure 29
OS7185
OS7191
OS7196