Ariens Pro Track 28 Manual page 16

Drift Cutters
(Figure 14)
Drift cutters break up snow drifts that are
taller than the auger housing and direct the
snow into the auger. Store the drift cutters on
the auger housing when not in use. Install
them as shown below so they are taller than
the snow to be cleared.
1. Stored Position
2. Operating
Position
Figure 14
Track Angle
(926041, 042, 043)
(Figure 15)
The track angle can be adjusted to position
the auger housing for level clearing, deep
cutting or transport.
Squeeze the handlebar trigger and press
down on the handlebars to move the auger
housing into an up position. Release the
trigger to hold the position.
Lift up on the handlebars and squeeze and
release the handlebar trigger to move the
auger housing into a down position.
1
2
OS7110
GB - 16
Normal
Transport
Deep Cutting
Figure 15
OS7111