Controls And Features; Operation - Ariens Razor Owner's/Operator's Manual

CONTROLS AND FEATURES

See Figure 6 for locations.
WARNING: Improper operation
can lead to injury. Learn what the
controls do and how they work.
Thoroughly read and understand
entire Operator Manual.
CAUTION: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Operator Presence Control (OPC)
Handle
(Figure 7)
CAUTION: Check function of
Operator Presence Control
Handle regularly. Improper
function could cause injury.
The OPC handle must be held against the
handlebar to start the engine and blade.
Figure 7
IMPORTANT: Releasing the operator
presence control handle stops engine and
blade within 3 seconds. Check this feature
frequently. If feature fails to operate,
disconnect spark plug wire and adjust as
necessary or have the unit inspected and
repaired by an authorized Ariens dealer
before using.
Handlebar
Adjust handlebar to a safe and comfortable
height. See HANDLEBAR HEIGHT on
page 22.
Recoil Starter Handle
When pulled, handle will turn engine over.

OPERATION

CUTTING HEIGHT ADJUSTMENT
Cutting Height Settings Chart
To change cutting height, move cutting height
levers one notch at a time to set desired
height (Figure 8).
1
1. Cutting Height Lever
2. Lowest Position
3. Highest Position
EN - 15
DANGER: Avoid injury from
rotating blade.
ALWAYS shut off engine before
adjusting cutting height.
Notch Cut grass length
1 25 mm
2 38 mm
3 51 mm
4 64 mm
5 76 mm
6 89 mm
7 102 mm
2
Figure 8
3