Connecting Headphones; Connecting Microphone; Microphone Jumper Settings - Creative Live! Drive II User Manual

To listen to an analog source (e.g.
CD Audio) using headphones,
make sure that in Surround Mixer,
the recording source selected is
"What U Hear". Otherwise, no
sound will be heard from the
headphones.
The shunt for Jumper C85 can be
found together with the packet of
screws provided.
4 Live Drive CT4860/CT4861
There are two types of headphones which you can connect to the Live! Drive:
Home audio or professional audio headphones, which are usually fitted with a ¼" stereo plug
Personal stereo headphones, which are usually fitted with a 3.5mm stereo plug, such as those
used for portable audio players.
There are two types of microphone which you can connect to the Live! Drive:
Dynamic microphone, which is usually fitted with a ¼" stereo plug, such as those used in
vocal performances
.
Condenser microphone, which is usually fitted with a 3.5mm stereo plug, such as the Telex
microphone bundled with Creative audio products.
By default, Live! Drive is set for use with a condenser microphone. To use a dynamic
microphone, you must place the shunt (jumper cap) onto Jumper C85 on the Live! Drive. See
Figure 4 on page 8 for the location of Jumper C85 on the Live! Drive.
Shunt
To use a dynamic
microphone,
place the shunt
onto Jumper C85.
To use a condenser
microphone,
remove the shunt
from Jumper C85
(default setting).
Jumper C85
Figure 2: Microphone jumper settings.
Shunt
Jumper C85
.