Front View - Zanussi ZWI71201WA User Manual

Graphic F
5 mm Hardwood strip
40
100
600-605

Front view

Where the appliance has been raised by
mounting onto a wooden base provided by
the installer. The material used to construct
the base should have anon slip surface, be
water repellent and if possible be one solid
piece.
If it is not possible to use one solid piece, due
to the additional height required, ensure that
any additional strips of timber are glued and
screwed to the underside of the base (see
Fig. F).
Graphic G
95
50
Top view
Drill four fixing holes see Fig. G
Position the base into the recess with its front
edge as far forward as the adjoining plinth
line will allow.
The reason for placing the base in this
position is to allow a small strip of
beading to be fitted in front of the appli-
ance feet.
www.zanussi.com
Additional pieces
of timber should run
from front to back
600-605
Front edge
Graphic H
490
Fix the base firmly to the floor using four ap-
propriate countersunk screws (see Fig. H).
With the appliance installed adjust all four
feet ensuring the machine is stable, and a
clearance of approximately 5 mm is left be-
tween the top of the machine and the under-
side of the worktop.
A final check for stability should be carried
out with the machine on spin with a load, this
will identify the need for any further fine ad-
justment to the feet.
490
A strip of beading approximately 605 mm W,
x 5 mm H, x 25 mm D must be screwed down
into the base directly in front of the machine's
feet, this will provide additional security.
If required an additional door magnet, part
number 1242394-00/3 and disc, part num-
ber 1242393-00/5 are available from spare
parts.
Hardwood strip
5 mm x 25 mm
5 x 25 x 605
600-605
27