Zanussi ZWI71201WA User Manual page 17

When no more water comes out, unscrew the
pump cover by turning it anti-clockwise and
remove the filter. Use pliers, if necessary. Al-
ways keep a rag nearby to dry up any water
spillage when removing the cover.
Clean the filter under a tap, to remove any
traces of fluff.
www.zanussi.com
Place a container
close to the pump (A)
to collect any spill-
age.
Pull out the emergen-
cy emptying hose (B),
place it in the con-
tainer and remove its
cap.
Remove foreign bod-
ies and fluff from the
filter seat and from
the pump impeller.
Check carefully
whether the pump im-
peller rotates (it ro-
tates jerkily). If it
doesn't rotate, please
contact your Service
Centre.
Caution! When the appliance is in use
and depending on the programme
selected there can be hot water in the pump.
Never remove the pump cover during a wash
cycle, always wait until the appliance has
finished the cycle, and is empty. When refitting
the pump cover, ensure it is securely re-
tightened so as to stop leaks and young
children being able to remove it.
Cleaning the water inlet filters
Important! If the appliance doesn't fill, takes
long to fill with water, the starting button blinks
yellow or the display (if available) shows the
relevant alarm (see chapter "What to do if..." for
more details), check if the water inlet filters are
blocked .
To clean the water inlet filters:
• Screw the hose back onto the tap. Make
sure the connection is tight.
Put the cap back on
the emergency emp-
tying hose and place
the latter back in its
seat.
Replace the filter into
the pump by inserting
it correctly into the
special guides.
Screw the pump cov-
er firmly by turning it
clockwise.
• Turn off the water
tap.
• Unscrew the hose
from the tap.
• Clean the filter in
the hose with a stiff
brush.
17