Speaker System Connections; Ferrite Core Connection - Zenith DVT723 Installation And Operating Manual

Connections (Continued)

Speaker System Connections

Connect the speaker wires the speaker terminals.
To obtain the best possible surround sound, adjust the speaker parameters; distance, level, etc..
Front speaker
(Right)
Rear speaker
(Right surround)
otes
• Be sure to match the speaker wire to the appropriate terminal on the connectors: + to + and – to –. If the cables are reversed,
the sound will be distorted and will lack bass.
• When making the sound louder, adjust the sound level carefully to avoid excessive volume output to the speakers.
• Only 2-channel stereo (Front Left, Front Right & Subwoofer) is abailable in VCR mode, thus sound might not be heard from cen-
ter or rear speakers during VCR playback. (For further details about sound mode, please refer to next page.)
• Do not remove the front covers of supplied speakers.

Ferrite Core Connection

Be sure to attach the ferrite core to the speaker wires
(for connecting to this unit).
This ferrite core can reduce noises.
How to attach the ferrite core
1
Press the stopper [a] of the ferrite core to open.
2
Wind the cable once on the ferrite core.
3
Close the ferrite core unitl it clicks.
ote
Attach the ferrite core near the unit (Refer to the fig.3 and
comment.).
Center speaker
Subwoofer
Front speaker
(Left)
Rear speaker
(Left surround)
The length here is
short as much as
possible.
13