Installing The Measurement Software, Applications, And Help - Agilent Technologies N4010A Getting Started Manual

NOTE
Getting Started

Installing the Measurement Software, Applications, and Help

Installing the Measurement Software, Applications, and
Help
The supplied N4010A Measurement Software, Applications, and Operating
Information CD-ROM contains all the applications, software components, and help
files needed for the Test Set to perform Bluetooth and 802.11 a/b/g WLAN device
tests.
Open the DVD box and refer to the Installation Guide contained inside.
Use the Installation Guide and, after starting the CD-ROM, the on-screen
instructions to view, copy, and install the Applications and Help Systems you
require.
If your PC does not have autostart enabled, use Windows Explorer to locate and
double click the
If the .NET Framework 1.1 SP1 is not detected on your PC, a message is displayed
asking you to confirm its installation from the N4010A CD-ROM. Confirm to
continue. If the .NET Framework is not installed the Installer halts and you cannot
proceed.
Typically, a PC re-start is required following the N4010A WLAN Test Suite
installation. If you are installing both WLAN and Bluetooth components, we
recommend that you install the N4010A WLAN Test Suite first, and install the
Bluetooth components following the PC re-start.
When you have completed the configuration of your PC and are ready to proceed,
continue in this Getting Started Guide at Chapter 2, "Making Your First
Measurements," on page 13.
12
(autorun.exe) file on the CD-ROM.
Chapter 1