Base Shifter Handle Assembly; Swivel Bar Attachment With Mounting Bracket - Invacare 9805 Owner's Manual

SECTION 4—ASSEMBLY

Base Shifter Handle Assembly

NOTE: For this procedure, refer to
FIGURE 4.3.
1. Insert the base shifter handle into the
cam lock assembly at the back of the
base.
2. Align the holes of the shifter handle
and cam lock assembly.
3. Tighten the thumbscrew to secure the
shifter handle in place.
NOTE: This should prevent the base shifter
handle from being removed.

Swivel Bar Attachment with Mounting Bracket

NOTE: For this procedure, refer to FIGURE 4.4.
1. Push the pin and washers up through the swivel bar pad.
2. Line-up hole in pin with mounting bracket holes and secure with shoulder screw and
nut provided.
NOTE: The swivel bar has hooks on both ends to accept the hardware used to attach the sling that
supports the patient during lift. The swivel bar pad should remain in place during normal use.
FIGURE 4.4 Swivel Bar Attachment with Mounting Bracket
Portable Patient Lift and Sling
NOTE: Make sure Pin and Washers are completely
pushed up through the Swivel Bar Pad.
Nut
Pin
Swivel Bar Pad
Base Shifter Handle
Thumbscrew
FIGURE 4.3 Base Shifter Handle Assembly
Shoulder
Screw
18
Cam Lock
Assembly
Part No 1024492