Weslo Pursuit 250 Fm Bike User Manual page 5

3. Whilst another person holds the Upright (13) in the
position shown, connect the Upper Wire (36) to the
Reed Switch Wire (43). Cut and remove the zip tie
holding the Reed Switch Wire to the Frame (1). Next,
connect the Resistance Cable (19) to the Lower Cable
(45) in the following way:
• See inset drawing A. Pull up on the metal bracket (A)
on the Lower Cable (45), and insert the tip of the
Resistance Cable (19) into the wire clip inside of the
metal bracket.
• See inset drawing B. Firmly pull the Resistance
Cable (19) and slide it into the metal bracket (A) on
the Lower Cable (45) as shown.
• See inset drawing C. Using pliers, squeeze the
prongs on the upper end of the metal bracket (A)
together.
Carefully pull the excess Upper Wire (36) out of the
top of the Upright (13), push the excess Cables (19, 45)
down into the Frame (1), and insert the Upright into the
Frame. Be careful to avoid pinching the Wires and
Cables. Next, attach the Upright with three M8 x 15mm
Screws (41), three M8 Lock Washers (20), and three
M8 Curved Washers (39).
4. Insert the Upper Wire (36) up through the plate on the
Handlebar (15), and insert the Handlebar into the
Upright (13). Be careful to avoid pinching the Upper
Wire. Attach the Handlebar with three M8 x 15mm
Screws (41), three M8 Lock Washers (20), and three
M8 Curved Washers (39).
3
19
45
39
20
41
A
A
19
45
4
15
41
39
20
41
5
Be careful to
avoid pinching
the wires and
cables whilst
inserting the
upright.
13
36
20
39
43
41
Zip Tie
41
39
20
1
C
B
A
19
45
Be careful to
avoid pinching
the upper wire.
36
41
20
20
39
13
A