Weslo Pursuit 250 Fm Bike User Manual page 10

3. Measure your heart rate if desired.
If there are
sheets of clear
plastic on the
metal contacts
on the handgrip
pulse sensor,
peel off the plas-
tic. To measure
your heart rate,
hold the handgrip
pulse sensor, with your palms resting against the
metal contacts. Avoid moving your hands or
gripping the contacts too tightly.
When your pulse
is detected, a
heart-shaped
symbol will flash
in the right side
of the display
each time your
heart beats, one
or two dashes
will appear, and then your heart rate will be shown.
For the most accurate heart rate reading, hold the
handgrip pulse sensor for at least 15 seconds. Note:
If you continue to hold the handgrip pulse sensor,
the display will show your heart rate for up to 30
seconds. The display will then show your heart
rate along with the other modes.
If your heart rate is not shown, make sure that your
hands are positioned as described. Be careful not
to move your hands excessively or to squeeze the
metal contacts too tightly. For optimal performance,
clean the metal contacts using a soft cloth; never
use alcohol, abrasives, or chemicals.
Metal
Contacts
WARNING:
is not a medical device. Various factors,
including the user's movement, may
affect the accuracy of heart rate readings.
The pulse sensor is intended only as an
exercise aid in determining heart rate
trends in general.
4. Listen to the FM radio if desired.
If the FM radio is not already turned on, rotate the
knob at the bottom of the console clockwise.
To select a radio station, press the up or down
arrow button beside the speaker; hold down the up
or down arrow button to scan for the next available
radio station. Note: To enhance reception, try repo-
sitioning the exercise cycle.
To adjust the volume of the radio, rotate the knob
at the bottom of the console.
To turn off the radio, rotate the knob at the bottom
of the console counterclockwise until you hear a
click.
5. Turn off the console.
To turn off the console, simply wait for a few min-
utes. The console has an "auto-off" feature. If the
pedals are not moved and the console buttons are
not pressed for a few minutes, the console will turn
off automatically to save the batteries. Note: If the
radio is on when the console turns off, the radio
will also turn off.
10
The pulse sensor