Assembly - Weslo Pursuit 250 Fm Bike User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable spanner
driver , and pliers
Use the part drawings below to identify the small parts used in assembly. The number in parentheses below
each drawing is the key number of the part, from the PART LIST on page 14. The number following the paren-
theses is the quantity needed for assembly. Note: Some small parts may have been preattached for ship-
ping. If a part is not in the parts bag, check to see if it has been preattached.
M8 Nylon
Locknut (10)–3
M4 x 12mm
Screw (49)–4
1. Whilst another person lifts the front of the Frame (1),
attach the Front Stabiliser (2) to the Frame with two
3/8" x 78mm Carriage Bolts (30) and two 3/8" Nylon
Locknuts (33) as shown. Make sure that the Front
Stabiliser is turned so the Wheels (23) are not
touching the floor.
2. Whilst another person lifts the rear of the Frame (1),
attach the Rear Stabiliser (6) with two 3/8" x 78mm
Carriage Bolts (30) and two 3/8" Nylon Locknuts (33).
.
3/8" Nylon
Locknut (33)–4 Washer (20)–6
M8 x 15mm
Screw (41)–6
M8 Curved
M8 Lock
Washer (39)–6
3/8" x 78mm Carriage Bolt (30)–4
1
30
23
2
33
1
4
, Phillips screw-
M8 Flat
Washer (51)–3
23
2
1
33
33
6
30