Weslo Momentum 800 Elliptical User Manual page 9

FEATURES OF THE CONSOLE
The easy-to-use console features seven modes that
provide instant exercise feedback during your work-
outs. The modes are described below.
• Speed—This mode displays your pedalling speed,
in kilometres per hour or miles per hour.
• Time—This mode displays the elapsed time. Note:
If you stop pedalling for a few seconds, the time
mode will pause.
• Distance—This mode displays the distance you
have pedalled, in kilometres or miles.
• Calories—This mode displays the approximate
number of calories you have burned.
• Fat Calories—This mode displays the approximate
number of fat calories you have burned (see FAT
BURNING on page 13).
• Pulse—This mode displays your heart rate when
you use the pulse sensor.
• Scan—This mode displays the speed, time, dis-
tance, calories, fat calories, and pulse modes, for a
few seconds each, in a repeating cycle. Note: The
pulse mode will be displayed only when the pulse
sensor is being used.
HOW TO OPERATE THE CONSOLE
Make sure there are batteries in the console (see
BATTERY REPLACEMENT on page 11). If there is a
sheet of clear plastic on the console, remove it.
Follow the steps below to operate the console.
1. To turn on the console, press the ON/RESET but-
ton or begin pedalling. The entire display will briefly
appear; the console will then be ready for use.
2. Select one of the modes:
Scan mode—
When the power
is turned on, the
scan mode will be
selected automati-
cally. A mode indi-
cator will appear
below the word
SCAN to show
that the scan
mode is selected,
and a second mode indicator will show which
mode is currently displayed. Note: If you have
selected a different mode, repeatedly press the
MODE button to reselect the scan mode.
Speed, time, dis-
tance, calories,
or fat calories
mode—To select
one of these
modes for contin-
uous display,
repeatedly press
the MODE button.
The mode indicators will show which mode is
selected. Make sure there is not a mode indicator
below the word SCAN.
To reset the display, press the ON/RESET button.
Note: The console can display speed and dis-
tance in either kilometres or miles. To change
the unit of measurement, press the ON/RESET
button for about five seconds. The letters km/h or
mph will appear in the display to show which unit of
measurement is selected. When the batteries are
replaced, it may be necessary to reselect the
desired unit of measurement.
9
Mode Indicators