Summary of Contents for Weslo Momentum 850 Elliptical
Page 1
Fax: 0 (444) 113 387 7125 To help us assist you, please be prepared to give the following information: • The MODEL NUMBER of the product (WLEVEL28830) • The NAME of the product (WESLO ® MOMENTUM 850 elliptical crosstrainer) • The SERIAL NUMBER of the product (see the front cover of this manual) •...
Page 2
HOW TO ORDER REPLACEMENT PARTS ......... . .Back Cover WESLO is a registered trademark of ICON Health & Fitness, Inc.
Page 3
PART LIST—Model No. WLEVEL28830 R0903A Key No. Qty. Description Key No. Qty. Description Frame Pedal Arm Bushing Upright M8 Nylon Locknut Left Side Shield Flywheel Washer Right Side Shield Pedal Arm Bolt Set Handlebar Arm M8 x 22mm Flat Head Screw Left Handlebar M4 x 16mm Screw Idler Assembly...
Congratulations for selecting the new WESLO tions after reading this manual, please call our ® MOMENTUM 850 elliptical crosstrainer. The MOMEN- Customer Service Department at 08457 089 009. To TUM 850 elliptical crosstrainer is an incredibly smooth help us assist you, please note the product model exerciser that moves your feet in a natural elliptical number and serial number before calling.
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical crosstrainer See the drawing below and locate the Reed Switch regularly. Replace any worn parts immediately. (53). Loosen, but do not remove, the indicated M4 x 16mm Screw (42). Slide the Reed Switch slightly To clean the elliptical crosstrainer, use a damp cloth toward or away from the Magnet (58) on the flywheel.
Page 6
2. Whilst another person lifts the back of the Frame (1), attach the Rear Stabilizer (28) to the Frame with two M8 x 53mm Button Bolts (34), two M8 Washers (48), and two M8 Nylon Locknuts (38). 3. Insert the Console Bracket (63) into the Upright (2) as shown.
FEATURES OF THE CONSOLE HOW TO OPERATE THE CONSOLE Make sure that there are batteries in the console (see BATTERY REPLACEMENT on page 12). If there is a thin sheet of clear plastic on the console, remove it. Follow the steps below to operate the console. 1.
Page 8
8. Identify the Left Pedal Arm (11). Attach a Pedal (13) to the Left Pedal Arm with two M6 x 48mm Flat Head Screws (36) as shown. Attach the other Pedal to the Right Pedal Arm (not shown) in the same way. 9.
Need help?
Do you have a question about the Momentum 850 Elliptical and is the answer not in the manual?
Questions and answers