Weslo Momentum 800 Elliptical User Manual page 5

2. Whilst another person lifts the back of the Frame (1),
attach the Rear Stabiliser (28) to the Frame with two
M10 x 75mm Carriage Bolts (34) and two M10 Nylon
Locknuts (33).
3. Whilst another person holds the Upright (2), remove
the indicated fasteners from the Pulse Bar (65) and the
Upright.
Slide the Pulse Bar (65) onto the indicated bracket on
the Upright (2). Attach the Pulse Bar with two M8 x
16mm Button Screws (68) and two M8 Split Washers
(69). Be careful to avoid pinching the wires.
4. The Console (23) requires three "AA" batteries; alka-
line batteries are recommended. Insert three batteries
into the battery compartment. Make sure that the bat-
teries are oriented as shown by the diagram inside
the battery compartment.
5. Whilst another person holds the Console (23) near the
Upright (2), connect the wires extending from the
Console to the Upper Wire (44) and the Pulse Wire
(64). Insert the excess wiring into the Upright.
Next, attach the Console (23) to the Upright (2) with
four M4 x 16mm Screws (42). Be careful to avoid
pinching the wires.
Turn the Resistance Knob (45) counterclockwise to
the lowest setting before going to the next step.
2
33
1
3
Fasteners
65
2
4
23
5
42
5
33
28
34
65
Bracket
2
Batteries
23
44
64
45
2
69
68