Mitsubishi FR-F500 Instruction Manual page 209

Name
Manual controller
DC tach. follower
Three speed selector
Motorized speed setter
Ratio setter
PG follower (Note 4)
Master controller (Note 4)
Soft starter (Note 4)
Deviation detector (Note 4)
Preamplifier (Note 4)
Pilot generator (Note 4)
Deviation sensor (Note 4)
Frequency setting
potentiometer (Note 4)
Frequency meter (Note 4)
Calibration resistor (Note 4)
Inverter setup software
Note: 1. "H" in the type code indicates 400V class.Power supply specifications of FR series controllers
and setters: 200VAC 50Hz, 200V/220VAC 60Hz, 115VAC 60Hz.
2. Rated power consumption
3. The intercompatibility attachment (FR-A5AT"") is required to mount the inverter, with the
exception of some models.
4. Options available in Japan only.
Type
For independent operation. With frequency meter,
FR-AX (Note 4)
frequency setting potentiometer and start switch.
For joint operation using external signals. (0 to
FR-AL (Note 4)
5VDC, 0 to 10VDC) (1VA) (Note 2)
For three-speed (high, middle, low) switching
FR-AT (Note 4)
operation. (1.5VA)
For remote operation. Allows operation to be
FR-FK (Note 4)
controlled from several places. (5VA)
For ratio control. Allows ratios to be set to five
FR-FH (Note 4)
inverters. (3VA)
For follow-up operation using the signal of a pilot
FR-FP
generator (PG). (2VA)
For parallel operation of several (up to 35)
FR-FG
inverters. (5VA)
For soft start and stop. Allows parallel operation
FR-FC
and acceleration/deceleration. (3VA)
For synchronous operation. Used with a deviation
FR-FD
sensor and synchro. (5VA)
Can be used as A/V conversion or operational
FR-FA
amplifier. (3VA)
For follow-up operation. 70/35VAC 500Hz (at
QVAH-10
2500r/min)
For synchronous operation (mechanical deviation
YVGC-500W-NS
detection). Output 90VAC/90
For frequency setting. Wire-wound type. 2W 1K
WA2W 1k
B characteristic.
Dedicated frequency meter (up to 120Hz scale).
YM206RI 1mA
Moving-coil DC ammeter.
For calibration of the frequency meter. Carbon-film
RV24YN 10k
type. B characteristic.
Supports steps from inverter start-up to
FR-SW0-SETUP-
maintenance. (FR-SW0-SETUP-WJ is Japanese
WE
version.)
193
Application, Specifications, etc.
OPTIONS
Applicable
Inverter
Common to
all models
7