M8 Nylon - Weider Pro 2000 User Manual

2. Attach the Upright (3) to the Base (1) with the two
M8 x 63mm Carriage Bolts (58) and two M8
Nylon Locknuts (69). Do not tighten the Nylon
Locknuts yet.
Attach the Press Frame Lock (39) to the Upright
(3) with an M8 x 63mm Bolt (66), two M8
Washers (71), and an M8 Nylon Locknut (69). Do
not overtighten the Nylon Locknut; the Press
Frame Lock must pivot easily.
3. Set two Weight Bumpers (17) over the indicated
holes in the Stabilizer (2). Insert two Weight
Guides (10) into the same holes. Make sure that
the indicated holes are closer to the bottom of
the Weight Guides. Secure the Weight Guides in
place with two M10 x 70mm Bolts (57), two M10
Washers (70), two Small Spacers (37), and two
M10 Nylon Locknuts (68).
Tighten the M10 Nylon Locknuts (68) used in
steps 1 and 3.
2
39
66
71
71
69
69
1
3
68
7
3
69
58
10
Holes
70
17
37
17
68
2
57