Weider Pro 2000 User Manual page 13

22. Wrap the Short Cable (47) over a 90mm Pulley
(34). Attach the Pulley and two Finger Guards
(35) to the Double "U"-bracket (42) with an M10
x 46mm Bolt (53) and an M10 Nylon Locknut
(68).
23. Attach the end of the Short Cable (47) to the
"U"-bracket (43) with an M8 Washer (71) and
an M8 Nylon Locknut (69). Note: Do not com-
pletely tighten the Nylon Locknut; it should
be threaded onto the Cable so that two
threads show past the Nylon Locknut, as
shown in the inset drawing.
24. Locate the Low Cable (48). Attach the Cable
inside the Base (1) with an M10 x 65mm Bolt
(55), two M10 Washers (70), two Large
Spacers (51), and an M10 Nylon Locknut (68).
25. Route the Low Cable (48) over a 90mm Pulley
(34). Attach the Pulley, a Cable Trap (36), and
two Finger Guards (35) to the second set of
holes from the bottom of the two Pulley Plates
(44) with an M10 x 52mm Bolt (52) and an M10
Nylon Locknut (68). Make sure that the Cable
Trap is oriented to hold the Cable in the
groove of the Pulley.
22
53
35
42
47
23
47
43
69
24
55
70
51
25
52
35
36
48
13
35
68
34
47
43
71
69
48
51
70
68
1
44
35
68
34