Troubleshooting And Maintenance - Weider 8950 User Manual

TROUBLESHOOTING AND MAINTENANCE

TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight
system, can stretch slightly when it is first used. If
there is slack in the cables before resistance is felt,
the cables should be tightened.
Slack can be removed by moving a 90mm Pulley (not
shown) and a pair of Pulley Covers (35) to a set of
holes closer to the centre of the two Pulley Plates
(44). Remove the M10 Nylon Locknut (68) and the
M10 x 52mm Bolt (52) from the Pulley, the Pulley
Covers, and the Pulley Plates. Re-attach the Pulley
and the Pulley Covers to the new set of holes in the
Pulley Plates with the Bolt and Nylon Locknut.
Slack can also be removed by moving the 90mm
Pulley (not shown) and the pair of Pulley Covers (35)
to the higher set of holes in the "U"-bracket (43).
Remove the M10 Nylon Locknut (68) and the M10 x
52mm Bolt (52) from the Pulley, the Pulley Covers, and
the "U"-Bracket. Re-attach the Pulley and the Pulley
Covers to the higher set of holes in the "U"-Bracket
with the Bolt and Locknut.
Slack can also be removed from the cables by tighten-
ing the M8 Washer (71) and M8 Nylon Locknut (69)
attaching the Short Cable (47) to the "U"-bracket (43).
To do this, you may need to remove the Pulley Covers
(35) from the "U"-bracket. The High Cable (not shown)
and the Small "U"-bracket (not shown) can be adjusted
in the same manner.
Make sure that the cables are not too tight, or the
Top Weight (14) will be lifted.
52
52
18
44
68
35
47
43
71
69
68
35