Saunier Duval ISOFAST CONDENS F 35 E Instructions For Use Installation And Servicing page 26

INSTALLERS
Settings
Accessories settings
3 - Repeater
REPEATER OFF
OK
4 - Room thermostat 2
THERMOSTAT2 OFF
OK
50
CONNECT
Hold the satellite button situated on the
back side of the radio relay box
depressed for 10 s.
OK To establish the connection, the radio
relay transmits signals until it is
recognized by the room thermostat
which validate the connection by the
following display :
REPEATER
THERMOSTAT 2
MODEM
EXT. SENSOR
The repeater is now operating
CONNECT
Disconnect the cable of the zone 1 room
thermostat, and connect it to thermostat
2. This is sufficient to have it recognized
OK
by the boiler.
Take the cable and reconnect it to zone
1 room thermostat and press the C
key. The following display will confirm
the connection:
THERMOSTAT 2
MODEM
EXT. SENSOR
REPEATER
The room thermostat 2 is now operating
Glossary for the
installater menu
Select the language
3/3
Installation config.
Clock zone 2
Radio accessories
ON
Heating regulation
OFF
OFF
OFF
Boiler config.
ON
OFF
OFF
OFF
Selecting the language on the thermostat's display.
Selecting the type of heating installation.
The ON position of this menu assigns the TA1
clock function to the radiator zone. In such case,
the ambient temperature at floor level is selected
from the TA1 user's menu.
Activating the various radio accessories on the
installation.
Selecting Automatic or Manual control mode.
In Automatic mode, the radiator temperature
adapts automatically to the heating requirements of
the room in which the thermostat is located, opera-
ting between the maximum and minimum tempera-
ture values set.
Selecting the boiler's main operating parameters
(power and heating circuit temperatures, pump
mode and airflow configuration).
51