Boiler Location, Flue And Ventilation - Saunier Duval Themaclassic F24E Instructions For Use Installation And Servicing

Fanned flue combination boiler; fanned flue system boiler
Hide thumbs Also See for Themaclassic F24E:
Table of Contents

Advertisement

6.1 Boiler Location
The recommended clearances are shown in diagram 6.1.
Note: The boiler must be mounted on a flat wall which is
sufficiently robust to take its weight when full. If in doubt, expert
advice should be obtained, in the event of the wall being found
not suitable.
The minimum acceptable spacings from the terminal to
obstructions, other terminals and ventilation openings are
shown in diagram 6.2. For Ireland the minimum distances for
the flue terminal positionning must be those detailed in I.S.813
"Domestic Gas Installations".
The boiler must be installed so that the terminal is exposed to
the external air.
6.2 Terminal guard, see diagram 6.3.
A terminal guard is required if persons could come into contact
with the terminal or the terminal could be subject to damage.
If a terminal guard is required, it must be positioned to provide
a minimum of 50mm clearance from any part of the terminal
and to be central over the terminal.
A suitable terminal guard type K3 can be supplied by:
Tower flue components Ltd.
Morley road
Tonbridge
Kent
TN9 1RA
6.3 Flue options
There are various flue systems to choose from as follows:
Horizontal telescopic top flue pack.
Horizontal top flue pack.
Vertical flue pack.
Twin flue pack.
Extensions, 90° and 45° bends.
For detailed information refer to flue options guide. This is
available from your nearest stockist.
6.4 Cupboard or compartment ventilation
The boiler can be fitted in a cupboard or compartment without
the need for permanent ventilation.
*
*
Note: It is permissible to
install the boiler with smaller
clearances than those quoted
PROVIDING that consideration
is given for Servicing/Repairs.

6 Boiler Location, Flue and Ventilation

25mm
above
elbow
20mm
5mm
600mm
20mm
*
450mm
*
300mm
Diagram 6.1
MINIMUM SITING DIMENSIONS FOR THE
POSITIONING OF FLUE TERMINALS
HORIZONTAL FLUES
A
DIRECTLY BELOW, ABOVE OR
HORIZONTALLY TO AN OPENING, AIR BRICK,
OPENING WINDOWS, AIR VENT, OR ANY
OTHER VENTILATION OPENING
B
BELOW GUTTER, DRAIN/SOIL PIPE
C
BELOW EAVES
D
BELOW A BALCONY OR CAR PORT
E
FROM VERTICAL DRAIN PIPES AND
SOIL PIPES
F FROM INTERNAL/EXTERNAL CORNERS
OR TO A BOUNDARY ALONGSIDE THE
TERMINAL
G
ABOVE ADJACENT GROUND OR
BALCONY LEVEL
H
FROM SURFACE OR A BOUNDARY
FACING THE TERMINAL
I
FACING TERMINALS
J
FROM OPENING (DOOR/WINDOW)
IN CAR PORT INTO DWELLING
K
VERTICAL FROM A TERMINAL
L
HORIZONTALLY FROM A TERMINAL
VERTICAL FLUES
M FROM ADJACENT WALL TO FLUE
N
FROM ANOTHER TERMINAL
P
FROM ADJACENT OPENING WINDOW
Q
ABOVE ROOF LEVEL
5mm
17
MM
300
75
200
200
150
300
300
600
1200
1200
1500
300
300
600
1000
300
Diagram 6.2
Diagram 6.3
4000124050-2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Themaclassic f18e sb

Table of Contents