Cleaning The Glass Cooktop - GE JD966 Owner's Manual

Cleaning the glass cooktop.

Clean your cooktop after
each spill.
The RAZOR SCRAPER is available
through our Parts Center. See
instructions under "To Order Parts"
section on next page.
Control Lockout
(on some models)
Begin by locking the cooktop; see
the Control Lockout section.
Normal Daily Use Cleaning
ONLY use the recommended cleaning
cream, Cerama Bryte™, on the glass
cooktop. Other creams may not be as
effective.
To maintain and protect the surface of
your glass cooktop, follow these steps.
Before using the cooktop for the first
time, clean it with the cooktop
cleaning cream. This helps protect
the top and makes clean-up easier.
Daily use of the cooktop cleaning
cream will help keep the cooktop
looking new and easy to clean.
Cleaning Pad for Burned-On Soil
Allow the cooktop to cool.
Apply a few drops of cooktop
cleaning cream to the soiled area.
Spread the cream across the entire
soiled area.
Using the cleaning pad, rub the
soiled area. Apply pressure, as
needed, while rubbing with the
pad.
Razor Scraper for Heavy, Burned-On Soil
Allow the cooktop to cool.
Apply a few drops of cooktop
cleaning cream to the soiled area.
Spread the cream across the entire
soiled area.
Hold scraper at approximately a
45° angle against the ceramic glass
surface and scrape the soil. It will
be necessary to press down on the
razor scraper while scraping the
soiled area.
Keep small amount of cream on
the soil as you scrape.
www.GEAppliances.com
Shake well. Then apply a few drops
of the cream directly to cooktop
surface on soiled area.
Use a paper towel or sponge to clean
the entire cooktop surface.
NOTE: It is very important that you DON'T use
the soiled area until it has been cleaned
thoroughly.
If any soil remains, repeat the steps
listed above as needed.
For additional protection, after all
soil has been removed, polish the
entire surface with the cooktop
cleaning cream.
WARNING: DAMAGE to your cooktop surface
may occur if you use pads other than BLUE
Scotch-Brite™ Multi-Purpose No Scratch by
3M.
After scraping with razor
scraper, use the cleaning pad with
cleaning cream to remove any
residual soil.
If any soil remains, repeat the
steps listed above as needed.
For additional protection, after
all soil has been removed, polish
the entire surface with the
cooktop cleaning cream.
NOTE: Razor blade is packed inverted for
safety reasons. Prior to use, the blade must be
rotated and reinserted into slot. Do not use a
dull or nicked blade.
31