Checking The Frame; Checking The Swingarm; Checking The Throttle Cable Routing - KTM 50 SX Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.37

Checking the frame

11.38

Checking the swingarm

11.39

Checking the throttle cable routing

Main work
–
Loosen screw
–
Position the chain guide.
–
Tighten screw.
Guideline
Remaining screws, chassis
101949-10
Finishing work
(50 SX)
–
Install the chain guard. (
x
–
Check the frame for cracking and deformation.
» If the frame exhibits cracking or deformation due to a mechanical impact:
–
Change the frame.
601599-01
x
–
Check the swingarm for damage, cracking, and deformation.
» If the swingarm exhibits damage, cracking, or deformation:
–
Change the swingarm.
601598-01
Preparatory work
–
Remove the seat. (
–
Turn the knurled screw on the fuel tap all the way clockwise.
–
Remove the fuel tank.
Main work
–
Check the throttle cable routing.
The throttle cable must be routed to the carburetor behind the handlebars above
the fuel tank bearing.
» If the throttle cable is not routed as specified:
–
Correct the throttle cable routing.
C00060-10
Finishing work
–
Install the fuel tank.
–
Mount the seat. (
.
1
p. 38)
x
Info
A frame that has been damaged due to a mechanical impact must
always be changed. Repair of the frame is not authorized by KTM.
x
Info
Always replace a damaged swingarm. Repair of the swingarm is not
authorized by KTM.
p. 34)
x
x
p. 35)
M6 10 Nm (7.4 lbf ft)
43