Installing The Fork Legs; Removing The Lower Triple Clamp - KTM 50 SX Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.7

Installing the fork legs

11.8

Removing the lower triple clamp

–
Loosen screws
–
Loosen screws
601594-10
x
Main work
–
Position the fork legs.
Info
The upper milled groove in the fork leg must be flush with the top edge of
the upper triple clamp.
Position bleeder screws
601595-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
601594-11
–
Position brake caliper, mount, and tighten screws
Guideline
Screw, front brake caliper
–
Position the brake line. Put the clamp on, and mount and tighten screws
601593-11
Finishing work
–
Install the front wheel.
x
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Dismount the start number plate. (
–
Dismount the front fender. (
Main work
–
Remove fuel tank breather
–
Loosen screw
and place it on one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
601604-10
. Remove the left fork leg.
3
. Remove the right fork leg.
4
to the front.
1
.
2
.
3
M8
( p. 55)
x
( p. 55)
x
( p. 28)
x
p. 33)
p. 33)
.
1
. Remove nut , take off the top triple clamp with the handlebar,
2 3
M8 20 Nm
(14.8 lbf ft)
M8 15 Nm
(11.1 lbf ft)
.
4
20 Nm Loctite
(14.8 lbf ft)
p. 27)
29
® 243™
.
5