Cleaning, Care; Cleaning Motorcycle - KTM 50 SX Owner's Manual

17

CLEANING, CARE

17.1

Cleaning motorcycle

Note
Material damage Damage and destruction of components by high-pressure cleaning equipment.
–
When cleaning the vehicle with a pressure cleaner, do not point the water jet directly onto electrical components, connectors,
cables, bearings, etc. Maintain a minimum distance of 60 cm between the nozzle of the pressure cleaner and the component.
Excessive pressure can cause malfunctions or destroy these parts.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
If you clean the motorcycle regularly, its value and appearance will be maintained over a long period.
Avoid direct sunshine on the motorcycle during cleaning.
–
Seal the exhaust system to prevent penetration by water.
–
First remove coarse dirt particles with a gentle water spray.
–
Spray very dirty areas with a normal motorcycle cleaner and then clean with a
brush.
Motorcycle cleaner (
Info
Use warm water containing normal motorcycle cleaner and a soft sponge.
Never apply motorcycle cleaner to the dry vehicle; always rinse with water
401061-01
first.
–
After rinsing the motorcycle with a gentle water spray, allow it to dry thoroughly.
–
Remove the plug from the exhaust system.
–
Empty the carburetor float chamber.
Warning
Danger of accidents Reduced braking efficiency due to a wet or dirty brake
system.
–
–
After cleaning, let your child ride the vehicle a short distance until the engine
warms up and the brakes are dried by applying the brakes carefully.
Info
The heat produced causes water at inaccessible locations in the engine and
the brake system to evaporate.
–
Push back the protection covers on the handlebar controls to allow water to evapo-
rate.
–
After the motorcycle has cooled off, lubricate all moving parts and bearings.
–
Clean the chain. (
–
Treat bare metal parts (except for brake discs and exhaust system) with
anti-corrosion materials.
Cleaning and preserving materials for metal, rubber and plastic (
–
Treat all plastic parts and powder-coated parts with a mild cleaning and care prod-
uct.
Paint cleaner and polish for high-gloss and matte finishes, bare metal and plastic
surfaces (
p. 83)
x
Clean or dry a dirty or wet brake system by riding and braking gently.
p. 39)
p. 84)
72
p. 83)