To Cancel The Timer - Hotpoint RB787 Use And Care Manual

OVEN CONTROL, CLOCK AND TIMER
Automatic Clock
The clock must be set for the automatic oven timing functions to work
properly. The time of day cannot be changed during a Timed Baking or
Self-Cleaning cycle.
To Set the Clock
1. Press the CLOCK pad.
CLOCK
2. Press the HOUR
and MIN. pads
to set the time
MIN.
HOUR
of day. The
clock will start
keeping time
within one
minute of releasing the pads. You
may press the CLOCK pad again
to immediately start the clock.
Timer
The timer is a minute timer and
does not control oven operations.
The maximum setting on the timer
is 11 hours and 59 minutes.

To Cancel the Timer

To cancel the timer, the remaining time must be in the display. To recall
the time remaining, press the TIMER ON/OFF pad once. To cancel the
timer press the TIMER ON/OFF pad again.
16
To Reset the Clock
1. Press the CLOCK pad, the
display will be blank. Press the
CLOCK pad again, the display
will flash.
2. Press the HOUR and MIN. pads
to set the correct time of day.
3. Press the CLOCK pad again for
an immediate start.
To Set the Timer
1. Press the TIMER
ON/OFF pad.
TIMER
ON/OFF
2. Press the HOUR and
MIN. pads until the
amount of time you
want shows in the
display. The timer will
start automatically
within a few seconds of
releasing the pad.
When the countdown is finished
the control will beep until the
TIMER ON/OFF pad is pressed.
To Blank Out the Clock
If you have several clocks in your
kitchen, you may wish to blank the
time of day display of your range.
If so, press the CLOCK pad.
Although you cannot see it, the
clock maintains the correct time of
day. It will reappear for the
duration of any function that
displays a Start Time or Cook
Time. Press the CLOCK pad again
to bring back the display.
To Reset the Timer
If the display is still showing the
time remaining, you may change it
by pressing the HOUR and MIN.
pads until the time you want
appears in the display.
If the remaining time is not in the
display, recall the remaining time
by pressing the TIMER ON/OFF
pad and then pressing the HOUR
and MIN. pads until the new time
you want shows on the display.