Clock And Timer - Hotpoint RGB508 Use And Care & Installation

F 11 the directions below if your range has the
O OW
clock and timer shown at the right.
You have the choice of having the timer show the
time counting down or the time of day. In either case,
the timer will signal at the
the time is up.
To Set the Clock
NOTE:
When you first plug in the range or after a
power failure, the entire Clock/Timer display will
light up.
1. Press the CLOCK pad.
2. Press and hold the UP or DOWN pad and the tilme
the time by single minutes, give the pads short taps.
3. Press the CLOCK pad to start the clock.
To Change or Cancel the Timer Setting
When the timer is counting down, use the UP and
DOWN pad to change the remaining time, or press
the TIMER ON/OFF pad to stop the timer. The tilmer
cannot be cwwelled unless you have fully completed
"set timer" instructions above.
Clock
Follow these directions if your range has the clock
and timer shown at the right. To set tbe clock, push
in the knob and turn it to the right. Let the knob out
when the clock hands reach the correct time. Continue
turning the knob to OFF.
Timer
The Timer has been combined with the range clock.
Use it to time all your precise cooking operations.
You'll recognize the Timer as the pointer that is
different in color than the clock hands.
Minutes are marked up to 30, and hours are marked
up to 4 on the center of the clock.
8

CLOCK AND TIMER

(on wme models)
end of the thmer period to
(Appearance may vary)
To Set the Timer
1. Press the TIMER ON/OFF pad.
2. Use the UP and DOWN pads to set the timer.
Short taps on the UP or DOWN pad change the
timer's setting one minute at a time. Pressing and
continuing to hold the UP pad increases the setting
ten minutes at a time.
3. Once you have set your timer, press the TIMER
ON/OFF pad to start timing.
As the timer counts down, a signal will indicate when
one minute is left. After this signal, the display will
count down in seconds. When time runs out, a final
stop the signal.
To Display the Clock While the
Timer Is Operating
Pressing the CLOCK pad while the timer is operating
will not interfere with the timer's operation; the
display will change to show the clock. bul the timer
will continue to count down and will still signal when
time is up. Press the TIMER ON/OFF pad again to
change the display back to show the timer.
12 ,
\
\.\\\ OFF
I
4 /, /
\.\
,
.
.
30 (,,1' '
/
6
To set the Timer, turn the knob to the Ieft-wilhout
pushing in—until the pointer reaches the number ol'
minutes or hours you want to time.
At the end of the set time, a buzzer sounds
to tell you time is up. Turn the knob-without
pushing in—until the pointer reaches OFF and the
buzzer stops.