Hotpoint RB787 Use And Care Manual page 31

How to Set Delay Start of Cleaning
Easy Steps:
1. Latch the door.
2. Turn the Oven Temperature Control knob to
AUTO SELF CLEAN.
3. Press the START TIME pad.
4. Press the HOUR and MIN. pads to set the time
of day you want cleaning to start. The Self-
Clean Cycle will automatically begin at the
time you selected.
Delay Start is setting the oven control to start the
clean cycle automatically at a later time than the
present time of day.
For example: Let's say it is 7:00 and you want the
oven to begin self-cleaning at 9:00 after you're
finished in the kitchen. The oven is just soiled a
normal amount so the normal Clean Time of 4 hours
and 20 minutes is preferred.
1. Follow the directions in the Before a Clean
Cycle section.
2. After closing the door,
slide the latch handle
to the right as far as
it will go.
Never force the latch
handle. Forcing the
handle will damage
the door lock mechanism.
3. Turn the Oven Temperature knob to the AUTO
SELF CLEAN position.
4. Press the START TIME pad.
START
TIME
5. Press the HOUR pad until 9:00 appears in
the display. The oven control is now set to
start cleaning in 2 hours, at 9:00.
HOUR
The Self-Clean Cycle will be set to
automatically begin at 9:00 and finish
at 1:20.
6. Both the OVEN ON light and the AUTO SELF
CLEAN light will flash when the Clean Time is
finished. Slide the latch handle to the left as far as
it will go, turn the Oven Temperature knob to OFF
and open the door.
Never force the latch handle. Wait until the AUTO
SELF CLEAN light flashes and the latch slides easily.
Forcing the latch handle may damage the door lock.
(continued next page)
31