NordicTrack Audiostrider Cx650 Elliptical User Manual page 11

12. Apply a generous amount of grease to the axle
on the Left Upper Body Leg (24) and to the axle
on the left Crank Arm (55). Then, apply grease
to two Large Wave Washers (89).
Slide an Upper Body Leg Spacer (9) and a
Large Wave Washer (89) onto the Left Upper
Body Leg (24). Make sure that the flat side of
the Upper Body Leg Spacer is facing out-
ward. Then, slide the other Large Wave Washer
onto the left Crank Arm (55).
Slide the left Pedal Arm (32) onto the Left
Upper Body Leg (24) while sliding the left Link
Arm (30) onto the axle on the left Crank Arm
(55).
Attach the Pedal Arm (32) to the Left Upper
Body Leg (24) with an M8 x 23mm Shoulder
Screw (86), an M8 Washer (95), an Axle Cover
(66), and an M8 x 23mm x 1mm Washer (31).
Then, attach the Link Arm (30) to the Crank Arm
(55) with an M8 x 23mm Shoulder Screw (86),
an M8 Washer (95), a Large Axle Cover (52),
and an M8 x 23mm x 1mm Washer (31).
Repeat this step for the right Pedal
Arm (32) and the right Link Arm (30).
See step 4. Tighten the M8 x 19mm Button
Screws (85).
13. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
12
24
Grease
9
89
31
66
95
86
32
30
31
95
52
86
11
32
30
89
55
Grease