Battery Page - GE Digital Energy 1018959 Operating Manual

3.3.2 Battery page

The Battery page shows the following information.
Parameter Name
Battery Status
Seconds On Battery
Estimated Minutes Remaining
Estimated Charge Remaining
Battery Voltage
Battery Current
Battery Temperature
Battery Ripple
Modifications reserved
OPM_CNT_SNM_BAS_CRD_1GB_V012.doc
Description
The current status of the battery:
1 – unknown
2 – normal The remaining run-time on batteries is greater than
the UPS low battery time (ref. UPS Config page)
3 – low The remaining run-time is less than or equal the UPS low
battery time (ref. UPS Config page)
4 – depleted The battery would be unable to sustain the load, if mains
power is lost
The time elapsed since the UPS switched to battery power (in seconds)
An estimate of the remaining run-time on batteries, under present load
conditions (in minutes)
An estimate of the remaining battery charge (in percentage – 100% is full
charge)
The present battery voltage (in Volts)
The battery flowing from/to the battery (in Amperes)
The ambient temperature of the UPS batteries (in °C)
The RSM ripple on the DC link (in Vrms)
Page 28/58
Operating Manual SNMP/Web Adapter