Log-On; Saving The Settings - GE Digital Energy 1018959 Operating Manual

•
Most SSH clients display the host key fingerprint at the start of the session. Make sure the
fingerprint shown matches the SNMP/Web adapter fingerprint (see Encryption section for details
on figuring out the SSH fingerprint)
•
A login window should then be available in a few seconds. The default username (login) and
password are ge and ge

2.1.3 Log-on

User authentication requires inputting the username and password. Remember that:
•
Both username and password are case-sensitive, and are always specified in lower case
•
By default, only one user is defined, with username and password set to ge and ge
•
Depending on the user class, not all commands and settings may be available

2.1.4 Saving the settings

Apart from some network parameters, most setting are immediately active. However, the adapter will
revert to the last save settings at reboot. Therefore, in order to permanently modify the SNMP/Web
adapter setting, remember to save the configuration after every change.
Modifications reserved
OPM_CNT_SNM_BAS_CRD_1GB_V012.doc
Page 13/58
Operating Manual SNMP/Web Adapter