Table of Contents
Advertisement
6 Faders
Cross-fader curve
You can change the way in which the signal is
changed from the A to B signals as the cross-fader is
moved, using the
C.F CURVE
When this control is fully counter-clockwise, it takes
a relatively large movement of the cross-fader from
Cross-fader start
When either of the cross-fader start menus (
7cFb
) has been set (is on, the
on the
position) and a suitable connection has
ON
been made from the
FADER START
panel which corresponds to the program number
selected), moving the cross-fader to the A and B
source automatically starts that source.
Alternatively
, press and hold down one of the
keys and the corresponding
FUNCTION
together.
While holding the
ENTER
down, press the
EXT EFFECT
fader
start on or off.
A
Cross-fader reverse
The
switch is used to
C.F REVERSE
reverse the direction of the cross-fader.
When the switch is set to
ON
of the cross-fader is reversed (that is, mov-
22
TASCAM X-9 Owner's Manual
control.
6cFA
or
C.F START
switch is
jack on the rear
key
ENTER
and
keys
FUNCTION
key to toggle cross-
, the direction
one side towards the center before the opposite cross-
fader signal level is increased.
When this control is fully clockwise, the opposite
cross-fader signal is heard after only a small move-
ment of the cross-fader towards the center.
While holding the
ENTER
down, press the
STEREO/MONO SPLIT
gle cross-fader
start on and off.
B
These methods are equivalent to the menu settings,
and changing the settings in this way will also
change the menu settings.
Use the
switch in the
C.F START
position to override the menu settings. In
other words, if the switch is
menu settings are on, cross-fader start is disabled.
However, setting this switch to
cally enable cross-fader start if the menu setting is
not set to on.
ing it towards
makes the
A
other way round). The cross-fader start is also
reversed (see "Cross-fader start" on page 22).
and
keys
FUNCTION
key to tog-
OFF
, and the
OFF
will not automati-
ON
signal louder and the
B
Advertisement
Table of Contents
