Signal Flow - Tascam X-9 Owner's Manual

The two signals that are controlled by the cross-fader
are known as and .
A B
You can set these to be any of the following using the
and
ASSIGN A ASSIGN B
right and left of the program faders:
Programs 1 through 4, a sam-
pler ( for A, and
SAMP 1
for B) or .
SAMP 2 THRU
The setting is equivalent
THRU
to OFF. In other words, if either

Signal flow

The signal flow is therefore:
Programs (and samplers)
are assigned to the
cross-fader A and B
signals
controls below and to the
Note that this is SAMP1
for the ASSIGN A control
the or the
ASSIGN A
, no signal is assigned to go through the cross-
THRU
fader on that side, and moving the cross-fader to the
side with the
THRU
When is selected, use the appropriate program
THRU
fader(s) and the master fader.
Move the fader from the left (fully A signal only) to
the right (fully B signal only) to perform the cross-
fade between the two signals.
Incoming signals are
assigned to programs
The cross-fader
determines the A and B
levels sent to the master
The master outputs
(what your audience
hears)
TASCAM X-9 Owner's Manual
4 Learning more
control is set to
ASSIGN B
setting has no effect on that side.
Programs (and
samplers not
assigned to the
cross-fader) go
straight to the
master, together
with the mic
15