6.
7. [Flatbed scanners only] While scanning images, the scanner carriage (lamp)
8. Your scanned images do not have the same color as the original.
9. When you select Display, or RGB Destination, or CMYK Destination profile
D-4
Microtek ScanWizard Pro for Windows
When you scan an 8-1/2-inch wide image, the left or right side of the image
is cut off.
Solution: A small margin on each side which will be cut off when you scan.
keeps going back and forth or idles, resulting in very long scan times.
Solution: This is called backtracking. Microtek scanners have a feature that
allows for recovery from image defects that result from the carriage
scanning and stopping during the scan. The carriage usually goes back and
reads part of the image once, then goes back a second time to patch the
images together and create a smooth picture. On some machines, due to
low amount of memory or a large virtual memory size, the software forces
the scanner to stop and start too many times, causing backtracking (which
may happen on almost every scan line).
To resolve this, you can:
•
Increase RAM in the computer by purchasing more memory.
Solution: To ensure the color consistency between scanner, monitor, and
printer, please make sure the ICC profiles selected in the Color Matching
Setup command under the Preferences menu that match with your color
monitor and color printer. If you cannot find the needed device profiles,
contact your device vendors to get the ICC profiles, then add them to
ScanWizard Pro.
in the Color Matching Setup dialog box, there is more than one profile have
same description (This is caused by some profiles installed by other
application, e.g. Photoshop, have different file name but same profile
description as ScanWizard Pro' s profile. ).
Solution: Select the profile that has higher version number and newer
profile created date. You can check these information of each profile by
clicking the Info button, and select the appropriate page, i.e. Display, or
RGB Destination, or CMYK Destination.
Need help?
Do you have a question about the ScanWizard Pro and is the answer not in the manual?