Scanning With The Ez Mode - Microtek ScanWizard EZ Reference Manual

Scanning with the EZ Mode

This section provides the easiest and most basic scanning scenario with the EZ
mode of the ScanWizard EZ scanning software.
1. Place the material to be scanned on the scan bed.
2. Launch ScanWizard EZ (either as a stand-alone by clicking on the program
icon, or by using the File-Import or Scan command from an application
program).
3. Click the Scan button to start scanning.
The ScanWizard EZ will automatically detect the material on the scan bed
and calibrate the scanner first; then, crop the image, and at last carry out
the final scan with scanning settings. When the scan is done, the output
image can be saved in a file, delivered to the specified location or opened in
your chosen application.
•
•
4 Microtek ScanWizard EZ Reference Manual
If ScanWizard EZ is launched from an application program, the
scanned image is delivered to your application, where the image can be
saved, printed, or modified further.
If ScanWizard EZ is launched as a stand-alone program, the scanned
image can be saved as a file in your selected folder or opened in an
application program.
Scan button